This summary of the video was created by an AI. It might contain some inaccuracies.
00:00:00 – 00:06:52
The video demonstrates the process of addressing the "Start Stop Service Required" light issue in a 2020 Volvo XC90, mainly caused by the support battery. Key steps include testing the support battery with a multimeter, performing a hard reset by disconnecting the terminals, and replacing the battery in the rear trunk. Proper installation of the new battery is crucial for the car to start. After reconnecting the negative cable and ensuring everything is connected correctly, a 15-minute reset is recommended before starting the vehicle to check if the issue persists. The successful process results in the warning message being resolved. Viewers are encouraged to engage with the video and stay updated for more content.
00:00:00
In this segment of the video, the presenter demonstrates how to address the “Start Stop Service Required” light issue in a 2020 Volvo XC90, often caused by the support battery. The key steps include testing the support battery with a multimeter, removing the battery for testing, identifying the voltage (12 volts), and determining if it’s a good or bad battery based on the reading. The presenter highlights the importance of disconnecting the terminals for a hard reset and stresses that even with a new battery, failure to disconnect the main battery can lead to the persistence of the warning message. Additionally, the process requires removing the 12-volt battery located in the rear trunk.
00:03:00
In this segment of the video, the key actions are to disconnect the negative cable, let the car sit for about 15 minutes with both batteries disconnected for a reset, and then install a new battery by connecting positive to positive and negative to negative. It is emphasized to ensure proper connection for the car to start. Finally, the negative battery cable needs to be reconnected using a 10-millimeter.
00:06:00
In this segment of the video, the speaker demonstrates how to replace and reconnect the support battery in a vehicle to resolve a start-stop message issue. It is emphasized to ensure that two connectors are properly connected. A hard reset is performed for about 15 minutes before starting the vehicle to verify if the message is gone. If the message persists, a longer reset may be required. The process is successful in the video, and viewers are encouraged to like, subscribe, and stay tuned for more content.