This summary of the video was created by an AI. It might contain some inaccuracies.
00:00:00 – 00:14:44
The video showcases the presenter shooting a ten and a half inch AR pistol with various accessories. Testing the rifle at 25 yards revealed a deviation that needed adjustment, but overall functioned flawlessly after firing 180 rounds. Despite firing around 210 rounds with good performance, fit and finish issues were noted, such as the buffer tube needing sanding. The presenter discussed improvements made to the rifle components and expressed plans to switch out the grip and mentioned challenges with flash can affecting rail section placement. Shooting 300 rounds through a Palmetto State PA-15 AR-15 pistol showed no malfunctions, using a mix of brass and steel case ammunition. The video concluded with the presenter promoting their Patreon and encouraging viewers to engage with the content.
00:00:00
In this segment of the video, the presenter showcases shooting his ten and a half inch AR pistol for the first time. They mention using Trigger Fanatics Lube and Cleaner on the gun. The pistol features a variety of accessories such as a Magpul grip, aluminum upper and lower, 12 inch free-float handrail, PSA fluted flash can, BCM hand stop, SBA3 brace, Streamlight ProTac HLX rifle light, primary arms micro red dot, and UTG flip-up sights. The presenter also mentions a Blue Force Gear quick adjust sling. It’s noted that the red dot didn’t need to be zeroed for shooting.
00:03:00
In this segment, the speaker talks about testing a rifle at 25 yards, noting a 10-inch deviation in the shots. The rifle, using 5.56 Wolf Steelcase ammo, has little recoil and a light trigger. The Red Dot is showing a slight right deviation, which the speaker intends to adjust. They mention the polished Palmetto State trigger and 158 carpenter bolt. After firing 180 rounds without malfunctions, they express surprise at the flawless performance, usually expecting issues during break-in periods.
00:06:00
In this part of the video, the speaker mentions that they have fired around 210 rounds with the gun and it has functioned well. They praise the recoil management with the SBA3 brace. However, they note that the fitment of the rifle is not great, specifically mentioning issues with the buffer tube sticking out too far. The speaker had to sand the buffer tube to resolve this. Overall, while the gun functions well, fit and finish are highlighted as areas of concern.
00:09:00
In this segment of the video, the speaker mentions tapping a pin with a pocket knife for the rifle and the improvement in the fit of different components. They express dislike for a Magpul grip and plan to switch it out for an ergo grip. Additionally, challenges with the flash can affecting rail section placement are noted. The speaker describes mounting a light on the rifle and discussing zeroing the sight at around 30-35 yards based on information learned from a video by Shawn Ryan.
00:12:00
In this part of the video, the speaker shoots 300 rounds through a Palmetto State PA-15 AR-15 pistol without experiencing any malfunctions. They mention using a mix of brass and steel case ammunition, with only the middle finger mag containing brass rounds. The video ends with the speaker promoting their Patreon, inviting viewers to like, share, and subscribe.